OPTIMASI PARAMETER PROSES 3D PRINTING TERHADAP KEKUATAN TARIK FILAMEN PLA FOOD GRADE
Keywords:
3D Printing, FDM, Taguchi Method, PLA, Tensile StengthAbstract
Rapid prototyping technology, especially in three-dimensional printing, has been successfully used in many aspects. One of the rapid prototyping technologies that are often found in the market today is the type of FDM technology. FDM is a 3D printing technique for printing products using filament as a material. The filament used is food grade Polylactic Acid (PLA). This study aims to obtain optimal parameters to produce FDM printed objects in terms of tensile strength. The method used in the process of optimizing the parameters of this process is the Taguchi method L9 (33) OA. The process parameters used in this research are Temperature Nozzle, Layer Height, and Print Speed. The results showed that the optimal process parameter values for tensile tests using food grade PLA filaments were Temperature Nozzle (210°C), Layer Height (0.1 mm) and Print Speed (65 mm/s).
Downloads
References
Andriyansyah, D., H. & P., 2018. Optimasi Parameter Proses 3D Printing Terhadap Kuat Tarik Filamen Polylactic Acid Menggunakan Metode Taguchi. Seminar Nasional Pendidikan Teknik Otomotif Fakultas Keguruan dan Ilmu Pendidikan - Universitas Muhammadiyah Purworejo, pp. 1-8.
O. C., A. S. & R. G., 2015. Fused Deposition Modelling With Polypropylene. ELSEVIER Materials and Design, pp. 1 - 9.
Pambudi, A. I., 2017. Analisis Pengaruh Internal Geometri Terhadap Sifat Mekanik Material Polylactic Acid (PLA) Dipreparasi Menggunakan 3D Printing. TUGAS AKHIR Institut Teknologi Sepuluh Nopember Surabaya, pp. 23 - 137.
Pratama, Y. B., H. & P., 2021. Pengaruh Parameter Proses Slicing Software Terhadap Kekasaran Permukaan Printing Part Filamen ST-PLA. Jurnal Teknologi Manufaktur, Volume 13, pp. 33-40.
Pristiansyah, H. & S., 2019. Optimasi Parameter Proses 3D Printing FDM Terhadap Akurasi Dimensi Menggunakan Filament Eflex. Manutech: Jurnal Teknologi Manufaktur , Volume 11, pp. 33-40.
Putra, K. S. & Sari, U. R., 2018. Pemanfaatan Teknologi 3D Printing Dalam Proses Desain Produk Gaya Hidup. SANSITEK.
Setiawan, A., 2017. Pengaruh Parameter Proses Ektrusi 3D Printer Terhadap Sifat Mekanis Cetak Komponen Berbahan Filament PLA (Poly Lactide Acid). Jurnal Teknika STTKD, Volume 4, pp. 1-8.
Tymark, B. M., Kreiger, M. & Pearce, J. M., 2014. Mechanical Properties of Components Fabricated with Open-Source 3-D Printers under Realistic Environmental Conditions. Materials and Design 58, pp. 242-246.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2021 Muhammad Habib Bari Bari, Pristiansyah Pristiansyah, Fajar Aswin

This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.