ANALISA KEKASARAN PERMUKAAN PROSES BOR BAJA SKD 11 PADA MESIN CNC
Keywords:
ANOVA, CNC, drilling, SKD 11, surface roughnessAbstract
The best quality of a component is a smooth surface. To achieve an optimum response, the variable setting of the process must be correct to be effective. SKD 11 steel includes the kind of tool steel that is frequently applied in the manufacturing industry as cutting tools, shear blades, stamping tools, punching, dies, and so on. Therefore, it is expected to have good surface roughness. This research will use a combination of variables to process spindle, feed rate, and cooling. The method used was experimental methods with tuning parameters. Based on research shows the most optimum gross response value was the 1600 RPM index, the rate of 120 mm per minute, and the cooling type of dramas. Variables that contribute significantly to the total variance of rudeness are the feed rate of 67.43 %.
Downloads
References
Ansyori, A. & Saputra, R., 2019. Pengaruh Diameter Mata Bor Terhadap Tingkat Kehalusan Permaukaan Lubang Bor Pada Proses Permesinan Bor Magnesium AZ31. Jurnal Teknik Mesin Universitas Bandar Lampung, pp. 7-18.
Dwijayanti, N., 2017. Optimasi Multirespon Gaya Tekan, Torsi, Keausan Tepi Pahat dan Kekasaran Permukaan Pada Proses Gurdi Untuk Material EMS-45 Dengan Menggunakan Metode Taguchi-GRA. Tugas Akhir, pp. 1-151.
Ibrahim, G. A., Subagio, H., Hamni, A. & Lestari, S. M. P., 2019. Analisa Kekasaran Permukaan dan Kebulatan Pada Permesinan Drill Paduan Magnesium Menggunakan Metode Taguchi. Jurnal Teknik Mesin, pp. 1-8.
Ilhamsyah, M. F., 2015. Pengaruh Variasi Debit dan Jenis Cairan Pendingin Terhadap Kekasaran Permukaan A1 6061 Pada Proses Drilling. Skripsi, pp. 1-71.
Ndaruhadi, P. W. & Santosa, B., 2015. Akurasi Lubang Bor Hasil Proses Pengeboran Pada Material SKD-11. Prosiding SNIJA, pp. 191-195.
Saputra, I., Ariyanto, N. P. & Febri, M., 2020. Pengaruh Temperatur Tempering Terhadap Pembentukan Struktur Mikro dan Kekerasan Baja SKD 11 Untuk Tool Steel. Jurnal Teknologi dan Riset Terapan, pp. 10-13.
Syahbuddin & Santoso, T. B., 2018. Optimasi Parameter Pemotongan Proses Drilling Terhadap Kekasaran Permukaan Dan Laju Pelepasan Material Menggunakan Metode Taguchi. Prosiding KITT (Konferensi Ilmiah Teknologi Texmaco), pp. 117-124.
Widarto, 2008. Teknik Permesinan Jilid 2. 无出版地:Direktorat Pembinaan Sekolah Menengah Kejuruan.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2022 Pajar Juliansah, Zulfitriyanto Zulfitriyanto
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
