PENGARUH PARAMETER DENGAN BESARNYA GETARAN TERHADAP KEKASARAN PERMUKAAN PADA PROSES GERINDA SILINDRIS MENGGUNAKAN MATERIAL BAJA S45C

Authors

  • Mei Adi Saputra Adi Politeknik Manufaktur Negeri Bangka Belitung
  • Muhamad Riva’i
  • Indra Feriadi

Keywords:

Vibration, Cylindrical Grinding, Surface Roughness

Abstract

Cylindrical grinding is a fundamental process in final machining, as it requires high dimensional accuracy and low surface roughness. The purpose of this study was to determine the value of vibration on surface roughness in the cylindrical grinding process. The method used is the Taguchi method. Variations in cylindrical grinding process parameters include workpiece rotation speed and cutting depth. This research shows thatThe faster the rotation of the workpiece and the depth of cutting, the higher the vibration and surface roughness, so that you know the amount of vibration that causes the level of surface roughness in S45C steel material.

Downloads

Download data is not yet available.

References

Mulyadi, Santoso. 2012, Pengaruh Kecepatan Potong, Gerak Makan Dan Ketebalan Pemotongan Terhadap Getaran Benda Kerja Pada Proses Sekrap. Jurnal Rotor, 5(1), 36-43.

Anam, Chairul dan Dian Ridlo Pamuji. 2017, Memprediksi Nilai Kekasaran Permukaan Dengan Besarnya Getaran Amplitudo Pada Gerak Cross Feed Proses Gerinda Datar Dengan Material Hardened Tool Steel SKD11. Jurnal Elemen, 4(1), 13-17.

Yanuar, Hari, Akhmad Syarief, dan Ach. Kusairi. 2014. Pengaruh Variasi Kecepatan Potong Dan Kedalaman Pemakanan Terhadap Kekasaran Permukaan Dengan Berbagai Media Pendingin Pada Proses Frais Konvensional. Jurnal Ilmiah Teknik Mesin Unlam, 03(1), 27-33

Anne, Afrian. 2016. Pengaruh Feeding dan Cutting Fluid Terhadap Kekasaran Permukaan Baja EMS 45 pada Proses Surface Grinding. Under Graduates Thesis, Universitas Negeri Semarang.

Zahia Hessainia, Ahmed Belbah, Mohamed Athmane Yallese, Tarek Mabouki, dan Jean-Francois Rigal, 2013. On the Prediction of Surface Roughness In the Hard Turning Based On Cutting Parameters and Tool Vibrations. Measurement, 46, 1671-1681.

Anam, Chairul dan Dian Ridlo Pamuji. 2017, Memprediksi Nilai Kekasaran Permukaan Dengan Besarnya Getaran Amplitudo Pada Gerak Cross Feed Proses Gerinda Datar Dengan Material Hardened Tool Steel SKD11. Jurnal Elemen

Downloads

Published

02-08-2021

How to Cite

Adi, M. A. S., Riva’i, M., & Feriadi, I. (2021). PENGARUH PARAMETER DENGAN BESARNYA GETARAN TERHADAP KEKASARAN PERMUKAAN PADA PROSES GERINDA SILINDRIS MENGGUNAKAN MATERIAL BAJA S45C. Prosiding Seminar Nasional Inovasi Teknologi Terapan, 1(01), 35–41. Retrieved from https://snitt.polman-babel.ac.id/index.php/snitt/article/view/22

Most read articles by the same author(s)

1 2 > >>